don't do the cool down if target bed temp is above configuration

k1/start_end.cfg

@@ -13,8 +13,11 @@ variable_carto_touch_retries: 20
 variable_carto_touch_samples: 3
 # where not using cartotouch what to heat nozzle to just before oozing
 variable_start_preheat_nozzle_temp: 150
+# whether to do cooldown routine in END_PRINT
 variable_end_print_cool_down: False
 variable_end_print_cool_down_nozzle_temp: 40.0
+# if target bed temp is above this the cool down is skipped
+variable_end_print_cool_down_max_bed_temp: 85.0
 gcode:
 
 [gcode_macro _CLIENT_VARIABLE]
@@ -153,6 +156,8 @@ gcode:
     {% set enable_disable_filament_sensor = printer["gcode_macro _START_END_PARAMS"].enable_disable_filament_sensor %}
     {% set end_print_cool_down = printer["gcode_macro _START_END_PARAMS"].end_print_cool_down %}
     {% set end_print_cool_down_nozzle_temp = printer["gcode_macro _START_END_PARAMS"].end_print_cool_down_nozzle_temp|float %}
+    {% set end_print_cool_down_max_bed_temp = printer["gcode_macro _START_END_PARAMS"].end_print_cool_down_max_bed_temp|float %}
+    {% set current_bed_temp = printer.heater_bed.temperature %}
 
     _CLIENT_RETRACT
     {% if bed_warp_stabilisation %}
@@ -173,7 +178,7 @@ gcode:
 
     M84  # motors off
 
-    {% if end_print_cool_down %}
+    {% if end_print_cool_down and current_bed_temp < end_print_cool_down_max_bed_temp %}
         SET_FAN_SPEED FAN=chamber SPEED=0
         SET_FAN_SPEED FAN=auxiliary SPEED=1
         SET_FAN_SPEED FAN=part SPEED=1