midi_arm2

BABOI Update

1. Download .bin Firmware File
2. Power Up BABOI
3. Connect Computer o Phone to BABOI Access Point
4. Go to webapge 192.168.1.1 in browser
5. Select "Update"
6. Select firmware File

##Processing Sketch update Just copy the .app file in the relase folder to your computer

LED's

Left LED

Red,Green,Blue -> Boot Yellow -> Ready for Connection Green -> Connection initiated

Right LED

Off > Not Connected Red > Pause Green > Live Blue > Acc/Gyro Cal Cyan > Mag Cal Magenta > Button Cal White > Glove Tension Strip Cal

Buttons

Left

CTRL-Button Short Press > Live/Pause Toggle Long Press > Gyro/Accelerometer Calibration Very Long Press > Mag Calibration

Front

A-Button

Right

B-Button

Calibration

• Best Way to calibrate is from the webpage
• Buttons might not work correctly initially. Calibrate from Webpage...
• Gyro/Accelerometer Calibration can be triggered both by 3 sec button press or webpage.
• Button/Mag calibration can only be triggered from webpage.
• If in doubt reset settings from webpage... (That will force a button recalibration on next start...)

Network

• Enable Network support in App
• Connect computer to "BABOI" access point
• Web Page is available at 192.168.1.1
• VPN/Firewall might enterfere. Traffic is on Port 2255. Connection is established via Broadcast, then communication switches to unicast.