door-monitor

About

This program uses a reed sensor to monitor the status of a door (open/closed) and in case of status change an email is send. A buzzer is also sound everytime the door is opened and every 5 minutes if it remains open.

Software

Developed using the Wiring Pi GPIO interface library.

Hardware

• Raspberry Pi 3 Model B Rev 1.2
• Reed switch
• 10kΩ (kohm) resistor
• 5V active buzzer
• Jumper wires

Breadboard view

Configuration

Edit door-sendmail.sh and modify the values of TO, FROM, SUBJECT and CONTENT variables as you wish.

Installation/Uninstallation

root@rpi3 ~ $ cd wiringpi-projects/door-monitor
root@rpi3 ~ $ make            # Compile door-monitor.c to door-monitor.elf
root@rpi3 ~ $ make install    # Install the .elf file under /root/bin/
root@rpi3 ~ $ make uninstall  # Remove the .elf file from /root/bin/
root@rpi3 ~ $ make clean      # Remove the .elf file from current dir

The make and make install targets will respectively compile door-monitor.c and install door-monitor.elf (compilation product) and door-sendmail.sh under /root/bin/. In case you want to choose a different directory modify the content of variable TARGETDIR in Makefile.

Setting up the mail server

First of all install the required packages by running the command below:

apt-get install mailutils ssmtp

Then edit file /etc/ssmtp/ssmtp.conf and modify it so that its contents look like this:

#
# Config file for sSMTP sendmail
#
# The person who gets all mail for userids < 1000
# Make this empty to disable rewriting.
root=postmaster

# The place where the mail goes. The actual machine name is required no 
# MX records are consulted. Commonly mailhosts are named mail.domain.com
mailhub=smtp.server.xz:port

# Where will the mail seem to come from?
#rewriteDomain=

# The full hostname
hostname=your-pi's-hostname

# Are users allowed to set their own From: address?
# YES - Allow the user to specify their own From: address
# NO - Use the system generated From: address
FromLineOverride=YES
[email protected]
AuthPass=secret-password
UseSTARTTLS=YES

Important: Make sure to modify lines mailhub, hostname, AuthUser, AuthPass at your discretion. For Gmail set mailhub=smtp.gmail.com:587

Execution using Crontab

Crontab allows you to automatically execute a comand or a shell script at given intervals.

Run crontab -e to edit current crontab file. The very first time you will be prompted to choose the editor of your choice.

Assuming that you didn't modify the installation dir, add the following entry at the end of the file:

@reboot /root/bin/door-monitor.elf

in order for door-monitor.elf to be executed every time the raspberry pi boots. Save changes and exit.

Developer

George Z. Zachos

Licence

GNU GENERAL PUBLIC LICENSE Version 2, June 1991