Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

common: added voltage and current multipliers to BATTERY_STATUS #233

Open
wants to merge 1 commit into
base: master
Choose a base branch
from
Open

common: added voltage and current multipliers to BATTERY_STATUS #233

Changes from all commits
Commits
Show all changes
1 commit
Select commit
File filter

Filter by extension

Filter by extension
Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
2 changes: 2 additions & 0 deletions message_definitions/v1.0/common.xml
View file
Open in desktop
Original file line number Diff line number Diff line change
Expand Up @@ -4615,6 +4615,8 @@
<field type="uint16_t[4]" name="voltages_ext" units="mV">Battery voltages for cells 11 to 14. Cells above the valid cell count for this battery should have a value of 0, where zero indicates not supported (note, this is different than for the voltages field and allows empty byte truncation). If the measured value is 0 then 1 should be sent instead.</field>
<field type="uint8_t" name="mode" enum="MAV_BATTERY_MODE">Battery mode. Default (0) is that battery mode reporting is not supported or battery is in normal-use mode.</field>
<field type="uint32_t" name="fault_bitmask" display="bitmask" enum="MAV_BATTERY_FAULT">Fault/health indications. These should be set when charge_state is MAV_BATTERY_CHARGE_STATE_FAILED or MAV_BATTERY_CHARGE_STATE_UNHEALTHY (if not, fault reporting is not supported).</field>
<field type="uint8_t" name="volt_mult">Multiplier which should be applied to voltages in this packet to allow for higher than 65.5V. A value of 0 means no scaling</field>
<field type="uint8_t" name="amp_mult">Multiplier which should be applied to currents in this packet to allow for higher than 327A. A value of 0 means no scaling</field>
</message>
<message id="148" name="AUTOPILOT_VERSION">
<description>Version and capability of autopilot software. This should be emitted in response to a request with MAV_CMD_REQUEST_MESSAGE.</description>
Expand Down