You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Lesson 3 Raspberry Pi option
When I run /home/pi/nightlight/app.py I get this message Check whether I2C enabled and Grove Base Hat RPi … inserted
Checked whether I2C was enabled. It was. I posted earlier about this.
Checked code several times, can’t see any errors, including a check against the code in the code-sensor/pi folder
Checked light sensor installation
Connected to A0 and only clips in one way
Took off and reinstalled Base HAT
Rebooted and the same error message occurred
I looked ahead in the course to see if I could check the Grove board is working in some other way but it all seems to build from this starting point
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Lesson 3 Raspberry Pi option
When I run /home/pi/nightlight/app.py I get this message
Check whether I2C enabled and Grove Base Hat RPi … inserted
Checked whether I2C was enabled. It was. I posted earlier about this.
Checked code several times, can’t see any errors, including a check against the code in the code-sensor/pi folder
Checked light sensor installation
Connected to A0 and only clips in one way
Took off and reinstalled Base HAT
Rebooted and the same error message occurred
I looked ahead in the course to see if I could check the Grove board is working in some other way but it all seems to build from this starting point
Beta Was this translation helpful? Give feedback.
All reactions