-
Notifications
You must be signed in to change notification settings - Fork 103
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Waveshare RP2040-Zero pinouts #113
Comments
Try the regular remapper.uf2 file if you're using pins 0 and 1, the remapper_waveshare_rp2040_pizero.uf2 firmware is for a different board (yeah, their naming is confusing). |
I can confirm the remapper.uf2 works with the Waveshare RP2040-Zero when using pins 0 and 1. |
Thanks! Will try this out also! |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I'm attempting to use a Waveshare RP2040-Zero with hid-remapper and wanted to double check the pin outs when using it with hid-remapper as when I connect anything to my RP2040-Zero I don't see anything when I'm on the Monitor tab of https://www.jfedor.org/hid-remapper-config/
Looking at the docs it says:
Looking at the Waveshare RP2040-Zero I think that would that map to?
I've checked continuity from the cable that I've soldered to those pins and that's good. I've tried using the remapper_waveshare_rp2040_pizero.uf2 firmware file from the last two releases.
The text was updated successfully, but these errors were encountered: