Move Cursor Between Monitors Using Whole Monitor Edge

[demonspork]

Currently, if I have 2 monitors side by side and one is larger than the other, the mouse only traverses between the monitors on their shared border, meaning there is a section of the larger monitor that the cursor just hits.

Is it possible to provide a config option that would allow us to use the entire monitor edge to move to the next monitor? It wouldn't need to be complex like adapting for scaling, it could be a simple jump to the nearest shared edge "If cursor attempts to pass through monitor edge at a location that doesn't share a border, jump cursor to nearest shared border on the same edge." so that as long as I'm moving the mouse towards my other monitor, even if I'm off by a little bit I still end up where I was heading.

This would prevent the occasional issue that's quite annoying when I'm trying to drag from one monitor to another and get stuck because I was a few inches off from the logical edge of the second monitor.