-
Notifications
You must be signed in to change notification settings - Fork 39
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
KeyboardController #5
Comments
Is your baud rate the same in PuTTY as it is in Serial1.begin? |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Hello, I am trying to connect a USB keyboard -> SAMD21 (Itsy Bitsy M0 Express) -> OLED.
I want to send ASCII from the USB keyboard to the M0 so I can output characters on the OLED.
I'm not sure how to use this library. I have installed it into Arduino IDE, used your KeyboardController.ino example code but I'm not sure how to read the serial output to test it.
I've connected a Prolific USB-to-Serial cable to the M0 (tx/Rx) and my computer (shows up as COM14) and opened the port via PuTTY to read the output and this is what I get in the console upon booting up the M0: " ▒▒▒▒▒▒ "
I am new to programming and working with microcontrollers, so if you could offer any help as to how to use this library that would be greatly appreciated!
(P.S. I found your Trinket M0 firmware UF2 stuff and tried that but I also couldn't get it to work on my Itsy Bitsy M0)
The text was updated successfully, but these errors were encountered: