You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Following the wiki about run embox on raspi, I'm try to run embox on my raspberry pi 0W. All things are the same except the make confload-platform/raspberry_pi/rpi0w and my SD card is mmcblk type rather than sda type.
After doing all step, I got nothing from the UART. Seems like this:
but when I connect the rpi0w to a screen. It flashed the fb_direct_access picture correctly about one or two seconds.
I later tried other os as raspberry pi os for testing broad. It works ok with UART.
My /dev/modem is a soft link to /dev/ttyUSB0 and bound-rate sets correct.
The text was updated successfully, but these errors were encountered:
Following the wiki about run embox on raspi, I'm try to run embox on my raspberry pi 0W. All things are the same except the
make confload-platform/raspberry_pi/rpi0w
and my SD card ismmcblk
type rather thansda
type.After doing all step, I got nothing from the UART. Seems like this:
but when I connect the rpi0w to a screen. It flashed the
fb_direct_access
picture correctly about one or two seconds.I later tried other os as raspberry pi os for testing broad. It works ok with UART.
My
/dev/modem
is a soft link to/dev/ttyUSB0
and bound-rate sets correct.The text was updated successfully, but these errors were encountered: