Mesh Detect

Firmware Options

🎥 1. OUI Sniffer

• Official OUI FW

• Detects specific OUI(s) via Bluetooth scanning.

• Alerts when targeted OUIs are detected.

• Flash via Arduino IDE.

2. 🌲 Deepwoods Device Detection

• Deepwoods Device Detection
• Scan WiFi and BT to form a baseline and alert to new devices.
• Detects and alerts on new devices.
• Flash via PlatformIO

3. 🛸 Drone Remote ID to Meshtastic - BT and WiFi

With Mesh-Mapper API 📡

• WiFi/BT Drone Remote id to Meshtastic

• Sends drone detection messages with ID, RSSI, MAC, Operator ID, Location, and more.

• WebUI plots drones, pilots, looks up FAA IDs and more. Increase range using node-mode firmware on multiple devices. TAK, Serial and ZMQ support.

• Flash via PlatformIO

3D Prints

• Mesh Detect SMA mount clip SMA mount clip for the Mesh Destect board by OrdoOuroboros https://www.printables.com/model/1294183-mesh-detect-board-sma-mount

Project Helpers

Configuring Attached Mesh Node

• Official Docs https://meshtastic.org/docs/configuration/module/serial/

Set the pcb mesh device to use serial mode, and configure the pins:

Ensure both the heltec and your receiver node are on the same channel. Set the pcb mesh settings to:

• Serial enabled
• 115200 baud rate
• Text message mode
• Pins defined RX/TX 19/20

Troubleshooting

• If your esp32 is not being detected or giving any errors, hold the boot button and plug in the device.
• Make sure you are using a Xiao esp32-S3 or c3 (all future dev is moving to the s3).

Resources

Mesh Detect board can be found on my Tindie Store: mesh-detect board

Credit: Firmware for RID and flasher based on work by cemaxecuter aka alphafox02. Modded with help of Colonel Panic.

• Original alphafox RID T-halow: https://github.com/alphafox02/T-Halow
• Thank you to Luke Switzer for the work on this project: https://github.com/lukeswitz/