Sonoff Zigbee Bridge Pro with Tasmota freezing when multiple commands received via Zigbee network #22309
Replies: 4 comments 6 replies
-
Moving to discussions since none of the needed issues Infos provided |
Beta Was this translation helpful? Give feedback.
-
Can you provide logs? |
Beta Was this translation helpful? Give feedback.
-
Yes of course. Just please let me know which logs you would need and where to get them? |
Beta Was this translation helpful? Give feedback.
-
While trying to replicate the issue I noticed a VBat error in the console, so replaced the power supply and now I am testing again. Let's see if it fixes the issue. |
Beta Was this translation helpful? Give feedback.
-
ZbBP with Tasmota stops working or becomes very sluggish after like 50 or more commands sent consequently in a matter of say 15 to 20 seconds.
I have an Orvibo Mix Switch (scenario button) with 6 gangs and when I click like 4 of them one after the other the ZBB becomes unresponsive.
The solution to this problem is a power cycle. Sometimes I also need to restart the Zigbee2Mqtt as well but power cycle is a mandatory step.
Checking the MQTT messages, every click of a button sends off the same message about 6 times in a matter of 10 seconds.
So I created a filter in Node-red that allows a message through every 10 seconds to avoid duplicates.
Zigbee2mqtt "debounce" on the other hand is not a good options as it delays the command for as long as new "same messages" come in.
Am I doing anything wrong or is it the nature of ZbBP and Tasmota to stop responding so quickly and is there a workaround?
Beta Was this translation helpful? Give feedback.
All reactions