-
Notifications
You must be signed in to change notification settings - Fork 7
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
JSON captures using dual appliance setup #9
Comments
I've just converted your data above into json for easier parsing, thanks for them. By way of comparison, this is from my evap-only system. Everything off
Cooling on fan 5
Fan (fresh air) speed 4
. |
From comparing the json's I think it should be pretty straightforward to add support! |
I'm leery of using the recirc, to be honest. The reason we like the evap fan is that we're getting nice, fresh air from outside and, on warm (but not hot) days that means free cool air in the evenings. |
Certainly the evap fan is fantastic for that, I'm using ours on 1 right now. I've got a uhoo environmental sensor in our bedroom, thanks to that I've been able to see the CO2 goes sky high overnight with 2 people in a closed room. In warmer months having the fresh air on fixes this, but in winter it's far too cold. This is when I'd like some recirc I could trigger any time CO2 gets a bit too high. |
Preliminary support here: #11 |
As requested, posting some JSON captures here, using my dual appliance setup. Hope these help and, as discussed in the other issue, more than willing to test other things out for you.
My specifics
MagiQtouch controller -> Braemar evaporative cooler -> Braemar ducted heating system
The MagiQtouch controls the evap, and the control board on the evap controls the heater accordingly.
Scenarios
JSON captures
Everything off
Evap cooling on, using setpoint 22°
Evap cooling on, using fan speed 5
Fan-only mode, fresh air (evap fan), speed 7
Fan-only mode, recirc air (heater fan), speed 10
Heater on, using setpoint 21°
The text was updated successfully, but these errors were encountered: