Board not showing up after updating bootloader

[SnappierSoap318]

Hi,

I was flashing my Supermini nrf52840, which was running 0.6.0 bootloader to the latest version.

The UF2 bootloader didn't work, I guess, because the uf2 info file didn't update to show the latest version.

I tried flashing the bootloader using CLI and I got the Device Programmed message.

After that the board doesn't seem to boot or is probably in a boot loop.

The inbuilt blinky doesn't load and on trying to put the board into DFU mode doesn't seem to work either.

any insights on how i should proceed?

[dhalbert]

Which version are you using? See also this new issue: #334.

[SnappierSoap318]

my issue is similar to that but i wasnt able to downgrade the bootloader.

The board was running 0.6.0, I tried flashing 0.9.1.