index.adoc

Effect of sheet rounding

Introduction

The 10 mm thick steel gusset plate shown has four identical embossed bolt holes. The inside perimeters of the two lower holes are completely fixed against displacement. The bolt load acting downward on the upper holes bears on the lower hal fon the inside edge of the hole. Determine the deformation and stress of the gusset plate. Check the effect of the rounding.

Model/Geometry

Note	First, we need to build the model, which we are going to do using the Gmsh-software.

The finished original geometry and the meshed model with 2 mm mesh-size:

Materials and boundary conditionas

Materials

The beam is made of steel, so we need to use the following data:

• E = 210 GPa → 210e3 N/mm²

• nu = 0.3

• rho = 7870 kg/m³ → 7870e-9 kg/mm³

Boundary conditions

The plate is fixed with two bolts (where would be contact between the plate and bolts named fixed). The force is applied, where the other two bolts press down the plate (named load).

Results

We provide Displacement and Von-Mises Criterions

Original geometry

Maximum displacement: 9.629 mm Maximum stress: 11 890 MPa

Modified geometry (rounding)

Maximum displacement: 7.852 mm Maximum stress: 7 047 MPa

Effects of rounding

• The deformation of the gusset plane is smaller (-18%).

• The maximum stress is also smaller (-41%).