NO SD CARD/ GPS reset

[kubelwagen]

I let the battery completely drain on my bgeige nano (1.3.5) while mounted on my car. The next morning I plugged it into USB to charge it and didn't realize the power switch was on, so I immediately shut it off.

Upon full charge, I powered the unit on and now am getting "NO SD CARD/ GPS reset". Bluetooth will connect, but Safecast:Drive is displaying "Err. Data". Unit is writing files to SD card (config.txt, log000**.TXT), so I know the SD card is good. I also tried another SD card, same result. I'm also seeing different LED behaviour on the card reader when the SD card is plugged in vs being unplugged.

I know the manual is careful to point out the unit should never receive USB power while switched on. Could this have caused damage in some way?

[robouden]

If the SDcard shows log000*.txt the config file can be wrong. One more thing to check if the safacast.txt(setup info) is on the sdcard.

regards
rob

[kubelwagen]

safecast.txt exists on the old card:

nm=bGeigie
did=2948
gt=0
gm=0
cpmf=334
cpmn=Cs137
bqmf=37
bqmn=Cs137
al=150
tz=4
cn=US
st=0
ss=0
sh=100
sm=0
cw=60

I tried copying it to the new card as well, same result.

config.txt exists on both the old card and the freshly formatted new card after running. On the old card, it's blank. On the new card, it shows:

9600,26,3,0,1,1,0
baud,escape,esc#,mode,verb,echo,ignoreRX

[kubelwagen]

Any other suggestions? I haven't been contributing to the project since this issue and I would live to get back into safecasting.

[sirselse]

Hi, have the same issue from the start (100% battery) "NO SD CARD/ GPS reset"

iOS :DriveCast message "awaiting a first measurement from BLEBee 0F097C91" still appears on screen but no data come.
Android :SafeCast Drive successfully connected to the bGeigie but the message "Err. Data" appears.

Hope this issue would be resolved
Regards