Wheel Speed Controller Harness

[ATATC]

3 3-pin connectors with buckles.

[DanielS928]

[ATATC]

Where are we planning to install the fuses, led, resistor, and shutoff? Are they embedded into the headers?

Btw @qmascarenhas please review this schematic.

[qmascarenhas]

Where are we planning to install the fuses, led, resistor, and shutoff? Are they embedded into the headers?

Btw @qmascarenhas please review this schematic.

@ATATC I did review the schematic with @DanielS928. Please note that this particular schematic is for VeC99. The schematic for VeC 2.0 will depend on what configuration RDU we are using.

For VeC99,

• fuses and resistor are on the rear electrical panel behind the driver and above the motor
• led is on the right front dash panel with the controller power switch
• emergency shut-off (main shut-off) is behind the left shoulder of the driver (accessible to both the driver and service crew in case of emergency)

[DanielS928]

@qmascarenhas These are the connectors for the wheel speed sensors:
Male end: https://www.digikey.ca/en/products/detail/phoenix-contact/1829400/2525207
Female end: https://www.digikey.ca/en/products/detail/phoenix-contact/1803646/260536

[ATATC]

@qmascarenhas These are the connectors for the wheel speed sensors: Male end: https://www.digikey.ca/en/products/detail/phoenix-contact/1829400/2525207 Female end: https://www.digikey.ca/en/products/detail/phoenix-contact/1803646/260536

Do you want him to purchase it? If so please create a new Component Proposal issue.