Replies: 3 comments
-
Beta Was this translation helpful? Give feedback.
-
Not an issue, converting to discussion |
Beta Was this translation helpful? Give feedback.
-
With the current version Serial Nmea 0183, USB Nmea 0183 and TCP Nmea 0183 for selecting Clear Filters, and then OK, closes the filter, when actually it should be a prompt I think. Something like "There is no sentence selected so don't apply a filter and uncheck [input or output]? Yes? No? If no, go back to the filter..so the user can pick a sentence. If yes, turn off the filter.
Checkbox "Use Garmin Mode for input" is now only used for a Serial Nmea 0183 receive input connection. It does not appear in UDP or TCP anymore.
Serial (nmea0183) , Network TCP (nmea0183 & nmea2000) and UDP (nmea0183 & nmea2000) all now have [Checkbox] "Output on this port (as Autopilot or Nmea Repeater" |
Beta Was this translation helpful? Give feedback.
-
Many thanks to everyone for our new user responsive Connections menu.
I need some review of this "typical setup" for inclusion in the manual.
This is not actually connected, and some experienced eyes should review as new users will be looking at it, so it should be correct.
I have an old nmea0183 EC autopilot out shown with in the 2nd position, but perhaps is should be configured separately for instruction?
Beta Was this translation helpful? Give feedback.
All reactions