Raspberry Pi Pico with waveshare 1.3inch using spi1 support

[sjgcornish]

Hi
I can not get this to display anything. Note using the Adafruit GFX and ST7789 Drive it works fine. I used the example TFT_graphictest_one_lib. It appears that spi1 is not supported by TFT_espi

Note the 1.3 display does not use the default pico spi pins, With the adafruit the drive is set up with
Adafruit_ST7789 tft = Adafruit_ST7789(TFT_CS, TFT_DC, TFT_MOSI, TFT_SCLK, TFT_RST);

But i see no equivalent the the tft_espi i.e.

TFT_eSPI tft = TFT_eSPI(TFT_CS, TFT_DC, TFT_MOSI, TFT_SCLK, TFT_RST);

Can this be added. I have tried a suggestion for examp #define spi0 spi1 but this results in a complie error. Any other work around?

#define USER_SETUP_ID 37

#define ST7789_DRIVER // Configure all registers

#define TFT_WIDTH 240
#define TFT_HEIGHT 240

//#define TFT_RGB_ORDER TFT_RGB // Colour order Red-Green-Blue
//#define TFT_RGB_ORDER TFT_BGR // Colour order Blue-Green-Red

//#define TFT_INVERSION_ON
//#define TFT_INVERSION_OFF

//Pico setup
#define TFT_MOSI 11 // Data out
//#define TFT_MISI not used
#define TFT_SCLK 10 // Clock out
#define TFT_CS 9
#define TFT_RST 12 // Or set to -1 and connect to Arduino RESET pin
#define TFT_DC 8
#define TFT_BL 13 // LED back-light control pin
#define TFT_BACKLIGHT_ON HIGH // Level to turn ON back-light (HIGH or LOW)

#define LOAD_GLCD // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH
#define LOAD_FONT2 // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters
#define LOAD_FONT4 // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters
#define LOAD_FONT6 // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm
#define LOAD_FONT7 // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:.
#define LOAD_FONT8 // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-.
//#define LOAD_FONT8N // Font 8. Alternative to Font 8 above, slightly narrower, so 3 digits fit a 160 pixel TFT
#define LOAD_GFXFF // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts

#define SMOOTH_FONT

#define SPI_FREQUENCY 27000000
#define SPI_READ_FREQUENCY 20000000
#define SPI_TOUCH_FREQUENCY 2500000